On A Wall Plate Or Wall - Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone Owner's Manual

6. Plug the adapter into a standard AC out-
let.
7. Route the AC adapter's cord and the
modular cord through the strain relief
slots on the bracket.
8. Lift the base's antenna to a vertical posi-
tion.

On a Wall Plate or Wall

Follow these steps to mount the base on a
wall plate.
1. Insert the bracket's tabs into the base's
lower set of tab slots. Press the
bracket's clips, lower them into the clip
slots, then release the clips.
2. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
back of the base.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
4. Route the AC adapter's cord through
one of the bracket's grooves. Plug the
modular cord's other end into the wall
plate jack, then align the base's keyhole
slots with the wall plate studs and slide
the base downward to secure it.
Short Modular Cord
Studs
AC Adapter's Cord
5. Plug the adapter into a standard AC out-
6. Press and slide up the handset holder to
7. Lift the base's antenna to an upright
To mount the base directly on a wall, follow
the steps under "On a Wall Plate or Wall,"
and follow these additional steps.
Note: You need two screws (not supplied)
with heads that fit into the keyhole slots on
the bottom of the base.
1. Drill two holes 3
2. Plug one end of the supplied long modu-
jack on the
3. Route the AC adapter's cord and the
jack.
4. Plug the modular cord's other end into a
Installation
let.
remove it, turn it over so the tab points
up, then insert it with the arrow pointing
downward until it snaps into place. The
tab at the top holds the handset on the
wall-mounted base.
(vertical) position.
15
/ inches (100 mm)
16
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall.
lar cord into the
TEL LINE
back of the base.
long modular cord through the bracket's
grooves.
modular phone jack, then align the
base's keyhole slots with the mounting
screws and slide the base downward to
secure it.
Mounting Screws
in Wall
1
/
8
jack on the
11