On A Wall Plate Or Wall - Radio Shack TAD-728 Owner's Manual

43-728.fm Page 11 Thursday, August 26, 1999 8:53 AM
3. Insert the supplied AC adapter's
barrel plug into the
jack on the back of the
ADAPTER
base.
4. Route the adapter's cord through
the strain relief slot on the base.
5. Plug the adapter into a standard AC
outlet. PF (power failure) flashes on
the digital display.
6. Lift the base's antenna to a vertical
position.

On a Wall Plate or Wall

1. Plug one end of the supplied short
modular cord into the
on the back of the base as in "On a
Desk," Step 1, on Page 10.
2. Insert the supplied AC adapter's
barrel plug into the
jack as in "On a Desk,"
ADAPTER
Step 3.
3. Route the adapter's cord through
DC 9V AC
4. Insert the mounting bracket's tabs
5. Plug the modular cord's other end
jack
TEL LINE
DC 9V AC
the strain relief slot on the bottom of
the base.
into the base's tab slots then press
down on the bracket's clips to insert
them into the clip slots.
into the wall plate jack, then align
the bracket's keyhole slots with the
wall plate studs and slide the base
downward to secure it.
11