Playing Messages; Adjusting The Answering System'svolume; Deleting Messages; Remote Operation - Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone Owner's Manual

PLAYING MESSAGES

After the answering system has recorded a
message, its message counter shows the to-
tal number of messages stored. If you have
new messages, the number flashes.
To play your messages, press
The answering system announces the num-
ber of new and old messages, then plays the
new messages. The message number ap-
pears as each message plays, and the an-
swering system announces the day and time
of the call at the end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP
To skip to the next message, press
ing playback.
To replay the current message from the be-
ginning, press . If you press
REPEAT
within about 2 seconds after a message be-
gins playing, the answering system replays
the previous message.
ADJUSTING THE
ANSWERING SYSTEM'S
VOLUME
To adjust the speaker's volume, repeatedly
press or on the base. The vol-
VOLUME
' ' ' '
ume setting from (lowest) to
pears in the message counter window.

DELETING MESSAGES

To delete the current message while it is
playing, press . The answering sys-
DELETE
tem beeps.
To delete all messages at once, while mes-
sages are not playing, hold down
the base until the answering system beeps
& & & &
and appears in the message counter win-
dow.
26
Note: You cannot delete new (unplayed)
messages. If you try to delete all messages
at once while you still have new messages,
the answering system sounds five quick
beeps and does not delete any messages.

REMOTE OPERATION

.
PLAY/STOP
While you are away from your home or of-
fice, you can use a touch-tone phone, or a
pulse (rotary) phone with a pocket tone dialer
(available through your local RadioShack
store), to enter your PIN (personal identifica-
tion number) and do any of the following:
• Set the answering system to answer or
again.
dur-
SKIP
• Listen to your messages.
• Record a new outgoing message.
REPEAT
• Record a memo.
• Erase messages.
• Monitor the room.
Note: You cannot remotely operate the an-
swering system using its handset or another
telephone on the same line as the answering
system.

SETTING THE PIN

'& '& '& '&
(highest) ap-
The answering system's two-digit remote op-
eration PIN prevents unauthorized remote
access to your messages. The PIN is preset
to 80. Follow these steps to change the PIN
to any number from 00 to 99.
Note: If you press
while changing the PIN, or wait more than 2
minutes between key presses, the answering
on
DELETE
system exits the PIN setting process. Start
again at Step 1.
1. Hold down
Answering System Operation
not answer calls.
SPEAKER
until the answering sys-
PIN
&& && && &&
tem beeps and appears in the mes-
sage counter window.
or
PLAY/STOP