Setting The Number Of Rings; Setting The Day/Time; Setting Auto Talk; Turning Caller Id/Call Waiting On Or Off - Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone Owner's Manual

SETTING THE NUMBER OF
RINGS
Set on the side of the base to
RING TIME
or to select how long the answering sys-
TS
tem waits to answer a call (3 rings, 5 rings, or
toll-saver).
Note: If you plan to check messages by long
distance, set
RING TIME
the Toll-Saver" on Page 27).

SETTING THE DAY/TIME

You must set the day of the week and time
so the answering system can record the cor-
rect day and time of each message.
Note: Enter each key press within about 2
minutes. Otherwise, the answering system
exits the time setting process and you must
begin again with Step 1.
1. Hold down on the base until the
CLOCK
answering system beeps. The answer-
ing system announces the currently set
day of the week and displays the day's
& & & &
number ( for Sunday,
so on).
2. To change the day, repeatedly press
on the base to move forward or
SKIP
on the base to move backward un-
PEAT
til the correct day appears, then press
. The answering system an-
CLOCK
nounces the hour.
3. To change the hour, repeatedly press
or until the correct hour
SKIP REPEAT
appears, then press
swering system announces the minutes.
4. To change the minutes, repeatedly
press or
SKIP REPEAT
minutes appear, then press
answering system announces "AM" or
7 7 7 7 F F F F
"PM," and or appears.
14
, ,
3 5
To check the day and time, press
The answering system announces the cur-
rently set day and time.
Note: If power fails, the clock retains the cur-
to (see "Using
TS
rent time. When the power is restored, it
starts counting again from the time the power
failed.

SETTING AUTO TALK

Your phone is preset so you must press
TALK
on, you can answer a call by lifting the hand-
set from the base or, if the handset is away
from the base, by pressing any key.
Follow these steps to turn auto talk on or off.
' ' ' '
for Monday, and
RE-
TURNING CALLER ID/CALL
WAITING ON OR OFF
. The an- If you have Call Waiting and Caller ID ser-
CLOCK
vice, you can set the answering system to
show Caller ID information for an incoming
call even while you are on the phone.
until the correct
. The
CLOCK
Installation
5. To switch between the AM and PM set-
ting, press or
SKIP REPEAT
. The answering system beeps
CLOCK
and announces the day and time.
to answer a call. With auto talk turned
1. Lift the handset and press
Caller ID setup menu appears on the
display with auto talk selected.
2. Press to change the auto
SELECT/CH
Ed Ed Ed Ed E\\ E\\ E\\ E\\
talk setting. or
the selected setting.
3. To clear the display when you finish,
press or return the handset to the
FUNC
base.
, then press
CLOCK .
FUNC . The
appears indicating