On A Wall Plate - Radio Shack TAD-733 Owner's Manual

43-733.fm Page 8 Friday, September 17, 1999 8:57 AM
4. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
5. Route the adapter's cord through
the strain relief slot on the back of
the base.
6. Insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the bottom of the base
and snap the tabs at the wide end of
the bracket into place.
8
7. Plug the adapter into a standard AC
jack on
DC 9V
8. Raise the base's antenna to a verti-

On a Wall Plate

1. Follow Steps 1–4 under "On a Desk
2. Route the modular cord through the
Strain
Relief
Slot
3. Route the end of the modular cord
outlet. The TAD-733 beeps and
appears.
cal position.
Top" on Page 7.
left groove on the bottom of the
base and the adapter cord through
the groove below the strain relief
slot.
through the hole in the bracket, and
insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the top of the base.
00
Strain
Relief
Slot