Safety Instructions - AEG VS92903M User Manual

 Disconnect the appliance from the power
 Do not use abrasive detergents or metal

2. SAFETY INSTRUCTIONS

2.1. Installation
WARNING!
Installation must be carried out by
qualified personnel only
 Remove the packaging material.
 Do not install or use the appliance if
damaged.
 Comply with the instructions
supplied with the appliance.
 Always pay attention when moving
the appliance and wear safety
gloves.
 Do not turn the appliance upside
down or tilt it! This may cause oil
to leak from the pump and
damage the equipment.
 Respect the minimum distance from
other appliances.
 Make sure the appliance is installed
and secured to a fixed structure.
 The sides of the appliance must be
adjacent to other equipment or
units having the same height.
2.2. Electrical connection
WARNING!
Risk of fire and electric shock.
 All the electrical connections must
be made by a qualified electrician.
 The appliance must be earthed.
 Make sure that all the electrical data
shown in the data plate of the
model correspond to those of the
system. Otherwise, contact an
electrician.
supply before carrying out any maintenance
operation.
scrapers to clean the appliance.
 Always use a correctly installed
shockproof socket.
 Do not use multi-plug adapters or
extension cables.
 Make sure not to damage the mains
plug and the mains cable. Contact
the Assistance Service or an
electrician to change any
damaged mains cable.
 Shock protection devices must be
fastened in such a way that they
cannot be removed without tools.
 Connect the mains plug to the mains
socket only once installation has
been completed. Make sure that
the mains plug can be accessed
after installation.
 Do not connect the mains plug if the
mains socket is loose.
 Do not pull the mains cable to
disconnect the appliance. Pull
only the mains plug.
 Use only suitable isolation devices:
circuit breakers, fuses (screw type
fuses must be removed from the
fuse holder), earth fault current
releases and relays.
The electric system must be
equipped with a means for
disconnection, with a contact
separation in all poles that provide
full disconnection under overvoltage
category III.
www.aeg.com
4