Maintenance - Makita AT638A Instruction Manual And Users Manual

CAUTION:
Do not place the contact element
against the workpiece with excessive force. Also,
pull the trigger fully and hold it on for 1-2 seconds
after stapling.
the contact element re-contacts the workpiece.
Contact actuation
against the workpiece.
2
Empty indicator
the staples when the empty indicator becomes red.
1.
Removing jammed staples
CAUTION:
Always return the trigger and
disconnect the hose before removing jammed
staples.
CAUTION:
Do not use deformed staples or
strip of staples. Failure to do so causes poor staple
feeding.
NOTE: Always hold the rear of the sliding door when
with the lever pressed when staples are stored in the
1
1
the staple rail.

MAINTENANCE

CAUTION:
Before attempting to perform
inspection or maintenance, always return the trig-
ger and disconnect the air hose from the tool.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Staples
Handle staple strips and their box carefully. If the staple
Avoid storing staples in a very humid or hot place or
place exposed to direct sunlight.
Maintenance of stapler
Always check the tool for its overall condition and loose
free movement of the contact element and trigger. Do
not use tool if the contact element or trigger sticks or
binds.
When the tool is not to be used for an extended period
store the tool in a safe place. Avoid exposure to direct
Maintenance of compressor, air set
and air hose
it may result in poor performance and possible tool
failure.
8 ENGLISH