Makita AT638A Instruction Manual
Narrow crown stapler
Hide thumbs
Also See for AT638A:
- Instruction manual (95 pages) ,
- Instruction manual and users manual (13 pages) ,
- Instruction manual (88 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita AT638A
Summary of Contents for Makita AT638A
- Page 1 INSTRUCTION MANUAL Narrow Crown Stapler AT638A Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: AT638A Air pressure 0.49 - 0.83 MPa (4.9 - 8.3 bar) Staple length 13 mm - 38 mm Staple capacity 100 pcs. Minimum hose diameter 6.5 mm Pneumatic tool oil ISO VG32 or equivalent Dimensions (L x W x H) - Page 3 Handle the tool carefully, as there is high pres- Safety devices sure inside the tool that can be dangerous if a Make sure all safety systems are in working crack is caused by rough handling (dropping order before operation. The tool must not oper- or striking).
-
Page 4: Installation
Keep the tool in tip-top condi- tion. Lubricate moving parts to prevent rusting and minimize friction-related wear. Wipe off all dust from the parts. Ask Makita authorized service center for peri- odical inspection of the tool. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. -
Page 5: Functional Description
Use an air hose as large and as short as possible to FUNCTIONAL assure continuous, efficient stapling operation. DESCRIPTION With an air pressure of 0.49 MPa (4.9 bar), an air hose with an internal diameter of over 6.5 mm and a length of less than 20 m is recommended when the interval between each stapling is 0.5 seconds. CAUTION: Before adjusting or checking Air supply hoses shall have a minimum working pres-... - Page 6 Air duster CAUTION: Do not aim the ejection port of the air duster to someone. Also, keep your hands and foot away from the ejection port. If the air duster button is accidentally pushed, it may cause a per- sonal injury. CAUTION: Always check your surroundings before using the air duster. Blown dust or objects may hit someone.
-
Page 7: Selecting The Operation Mode
OPERATION CAUTION: Make sure all safety systems are in working order before operation. Selecting the operation mode CAUTION: Always make sure that the actua- tion mode selector is properly set to the position for the desired stapling mode before stapling. ► 1 . -
Page 8: Maintenance
Follow the procedure of “Removing staples” to remove CAUTION: Do not place the contact element the strip of staples, and remove jammed staples from against the workpiece with excessive force. Also, the staple rail. pull the trigger fully and hold it on for 1-2 seconds after stapling. Even in the “Single sequential actuation” mode, half- MAINTENANCE pulled trigger causes an unexpected stapling, when the contact element re-contacts the workpiece. CAUTION: Before attempting to perform Contact actuation... -
Page 9: Optional Accessories
OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service ► 1 . - Page 12 Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan AT638A-ENAU-1604 www.makita.com 20160624...