Functional Description - Makita AT638A Instruction Manual And Users Manual

Use an air hose as large and as short as possible to
with an internal diameter of over 6.5 mm and a length
of less than 20 m is recommended when the interval
between each stapling is 0.5 seconds.
Air supply hoses shall have a minimum working pres-
sure rating of 1.03 MPa (10.3 bar) or 150 percent of the
maximum pressure produced in the system whichever
is higher.
Lubrication
for every 50 staples.
tool oil by placing 2 (two) or 3 (three) drops into the air
times after pneumatic tool oil is introduced.
1. Pneumatic tool oil
FUNCTIONAL
DESCRIPTION
CAUTION:
function on the tool, always return the trigger and
disconnect the air hose from the tool.
Adjusting depth of stapling
1.
If staples cannot be driven deep enough even when the
air pressure.
when the tool is used with lower air pressure and the
Hook
1
CAUTION:
tion or on potentially unstable surface.
CAUTION:
waist belt.
1. Hook
5 ENGLISH
Before adjusting or checking
B
A
Never hook the tool at high loca-
Do not hang the hook from the
1
1