Table of Contents
Advertisement
3K5-2
1-6-2
Upgrading the firmware (DP-670/models with monochrome touch panel)
Follow the procedure below to upgrade the firmware.
Firmware upgrading requires the following tools:
Compact Flash (Products manufactured by SANDISK are recommended.)
NOTE
When writing data to a new Compact Flash from a computer, be sure to format it in advance.
Procedure
1. Press the power key on the operation panel
to off. Make sure that the power indicator
and the memory indicator are off before
turning off the main power switch. And then
unplug the power cable from the wall outlet.
2. Remove two screws and remove the right
upper plate lid.
3. Insert Compact Flash in a notch hole of the
machine.
Insert the surface of Compact Flash toward
the machine rear.
4. Insert the power plug and turn the main
power switch on. Upgrading firmware starts .
Caution:
Never turn the main power switch off during
upgrading.
5. [Completed] is displayed on the touch panel
when upgrading is complete.
6. Press the power key on the operation panel
to off. Make sure that the power indicator
and the memory indicator are off before
turning off the main power switch. And then
unplug the power cable from the wall outlet.
7. Remove Compact Flash from the machine.
8. Refit the right upper plate lid.
9. Insert the power plug and turn the main
power switch on.
1-6-2
Compact Flash
Screw
Right upper plate lid
Screw
Service Manual
Figure 1-6-2
Y108671-9
Hide quick links:
Advertisement
Table of Contents
