Kusam-meco KM 711 Operation Manual

Ac/dc dual display digital multimeter with vfd function

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Enlarged version

LIST OF PRODUCTS

* Digital Multimeter

* Digital AC & AC/DC Clampmeter

* AC Clamp Adaptor

* AC/DC Current Adaptor

* Thermo Anemometer

* Thermo Hygrometer

* Distance Meter

* Digital Lux Meter

* Network Cable Tester

* Power Factor Regulator

* Earth Resistance Tester

* Digital Panel Meters

* DC Power Supplies

* High Voltage Detector

* Calibrators

* Gas Analysers

* Frequency Counter

* Function Generator

* Phasing Sticks

* Battery Tester

* Waterproof Pen Testers

* Solar Power Meter

* EMF Detector

* Wood, Paper & Grain Moisture Meter

* Transistorised Electronic Analog & Digital

Insulation Resistance Testers(upto 10 KV)

* Digital Sound Level Meter & Sound Level

Calibrator

* Digital contact & Non-contact Type Tachometer

* Digital Non-contact (infrared) Thermometer

* Maximum Demand Controller/Digital Power

Meter

* Digital Hand Held Temperature Indicators

AC/DC DUAL DISPLAY

DIGITAL MULTIMETER

MODEL - KM 711

OPERATION

MANUAL

Table of Contents

Need help?

Do you have a question about the KM 711 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kusam-meco KM 711

Page 1 * Thermo Anemometer AC/DC DUAL DISPLAY * Thermo Hygrometer * Distance Meter DIGITAL MULTIMETER * Digital Lux Meter MODEL - KM 711 * Network Cable Tester * Power Factor Regulator * Earth Resistance Tester * Digital Panel Meters * DC Power Supplies...
Page 2 DMM to a circuit or have the DMM on wrong setting, you damage the meter and possibly hurt yourself. You can also get into trouble if you try to measure the MODEL - KM 711 voltage across a charged capacitor. DMM users frequently burn their meters by trying to...
Page 3: Table Of Contents
AC & DC. Terminals (to COM) measurement category: : Category II 1000V, Category III 600V and Category IV 300V AC & DC. A /mAµA : Category III 600 Volts AC and 300 Volts DC. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 4 Do not touch test lead tips or the circuit being tested while power is applied to the circuit being measured. Keep your fingers behind the finger guards of the test leads KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 5: Features
Hz Line Level Frequency Power consumption : 5.4mA typical Hz Logic Level Frequency Low battery : Below approx. 2.4V Diode Test & Continuity Test APO Timing : Idle for 34 minutes APO Consumption : 10µA typical KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 6: Electrical Specification
Dimension : 186(L) X 87(W) X 35.5(H)mm 600.0 198(L) X 97(W) X 55(H)mm with holster. ±(2.0%rdg + 5dgts) 1000 Weight : 340gm; 430gm with holster. Input Impedance : 10M , 50pF nominal Accessories : Test leads(pair),User's Manual, Holster, Batteries installed. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 7 9A continuous, >9A to 15A for 30 seconds max with Specified accuracy plus 5 minutes cool down interval. 250 digits for change > 5ms in duration AUDIBLE CONTINUITY TESTER Response Time Audible Threshold between 10 and 120 < 32ms KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 8 A - 0.045V/A Sensitivity : 5Hz--20Hz : > 1Vrms Sine wave; 9A continuous, >9A to 15A for 30 seconds max with 20Hz--300kHz : > 2.6Vp; or 1.9Vrms Sine wave. 5 minutes cool down interval. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 9: Product Description
Red (+) test probe for direct contact measurement. A mA DIODE TESTER Test Current Open Circuit Range (Typical) Voltage <1.8V DC typical 1.000V 0.2mA MAX 0.6A 300V CAT IV FUSED 600V CAT III FUSED 1000V CATII KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 10: Measurement Procedure
7) Input Jack (+) for milli-amp (mA) & micro-amp ( A) functions. MAX 0.6A MAX 0.6A 300V CAT IV 300V CAT IV FUSED FUSED 600V CAT III 600V CAT III FUSED FUSED 1000V CATII 1000V CATII KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 11 If the rotary-switch position. Press the RANGE button reading shows zero, select lower voltage range momentarily to select other ranges only when for better sensitivity. needed. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 12 Hz (Logic Level) is set at the highest mA A available sensitivity for logic level frequency 300V CAT IV MAX 0.6A measurements. 600V CAT III FUSED FUSED 1000V CATII KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 13 5ms-MAX SELECT SELECT RANGE HOLD SELECT mA A mA A MAX 0.6A 300V CAT IV FUSED 600V CAT III FUSED 1000V CATII MAX 0.6A 300V CAT IV FUSED 600V CAT III FUSED 1000V CATII KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 14 Pico Farad (pF). CAUTION mA A Discharge capacitors before making any measurement. Large value capacitors should be MAX 0.6A 300V CAT IV FUSED 600V CAT III FUSED 1000V CATII discharged through an appropriate resistance load. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 15 A mA A (+) test probe for direct contact measurements. MAX 0.6A 300V CAT IV MAX 0.6A 300V CAT IV FUSED 600V CAT III FUSED 600V CAT III FUSED FUSED 1000V CATII 1000V CATII KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 16 Press the button momentarily again can toggle the combination use of HOLD feature. Press the button for 1 second or more to exit CREST-MAX capture mode. Auto-ranging and Auto-Power Off are disabled automatically in this mode. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 17: Maintenance
Refer to the on to temporarily disable the Auto-Power-Off WARRANTY selection for obtaining warranty or (APO) feature. Turn the rotary switch OFF and then repairing service. back on to resume. KUSAM-MECO April 2011 KUSAM-MECO April 2011...
Page 18: Test Certificate
Re-fasten the screws. Fuse replacement (and also battery replace- ment for splash proof version without battery KM 711 MODEL NO. ___________ access door): Loosen the 4 screws from the case bottom. Lift the end of the case bottom nearest the input jacks SERIAL NO.
Page 19: Warranty
WARRANTY “KUSAM-MECO’s” warranty obligation is limited, at option, free of charge repair, or replacement of Each “KUSAM-MECO” product is warranted to be a defective product which is returned to a free from defects in material and workmanship “KUSAM-MECO” authorized service center within under normal use &...

Kusam-meco KM 711 Operation Manual

Quick Links

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Kusam-meco KM 711

Summary of Contents for Kusam-meco KM 711

Table of Contents