Related Manuals for Malloca K1506
Summary of Contents for Malloca K1506
- Page 1 K1506/K1509/ K1506 TC/K1507 BUILT-IN HOOD USER’S MANUAL INSTRUCTIONS FOR INSTALLATION AND USE Please Read The User Manual Carefully!
-
Page 2: Table Of Contents
1 TECHNICAL DRAWING 2 WARNINGS AND SAFETY PRECAUTIONS 2.1 Life-Threatening Danger, Poisoning Danger 2.2 Danger of electric shock! 2.3 Danger of physical injury! 2.4 Danger of burn, danger of electric shock! 2.5 Dangers of fire and physical injury! 3 USAGES WITH AND WITHOUT CARBON USE 3.1 Replacement of Carbon Filter 3.2 Replacement of AF 90 Carbon Filter 3.3 Replacement of AF 100 Carbon Filter... -
Page 3: Technical Drawing
K1509 K1507... -
Page 4: Warnings And Safety Precautions
2 WARNINGS AND SAFETY PRECAUTIONS ■ This appliance can be used by children the relevant authorities. (This warning does not apply to uses without flue.) aged from 8 years and above and persons with reduced physical, sensory or mental capabili- ■... - Page 5 ■ Gas or fuel oil burning appliances, such as minimum distance must be 65 cm between the room heaters, which share the same environ- product and any electric cooker; and 75 cm be- ment with your product, must be fully insulated tween it and any gas ranges or cookers burning from the exhaust of this product or they must be other fuels.
-
Page 6: Life-Threatening Danger, Poisoning Danger
2.1 Life-Threatening Danger, Poiso- DANGER ning Danger Fire danger! DANGER Due to sparkling. Installation of appliance over There are life-threatening danger and poisoning a heating device that is heated by using solid danger due to reabsorbed combustion gases. fuels (for ex. wood or coal) is only allowed if an During the air discharge outlet use, unless suffi- non-detachable cover is present. -
Page 7: Danger Of Burn, Danger Of Electric Shock
DANGER NOTE If the feeder cable is damaged, it must be 2.4 Danger of burn, danger of elect- replaced by its manufacturer or its authorized technical service or any other personnel shock! qualified at the same level, in order to avoid any ■... -
Page 8: Usages With And Without Carbon Use
3 USAGES WITH AND WITHOUT CARBON USE You can use this appliance in exhaust air mode and ventilated air mode. Ventilated air mode Exhaust air mode Absorbed air is cleaned by the grease filters The absorbed air is cleaned by the grease filters, and an active carbon filter, and then it is and is discharged through a piping system. -
Page 9: Replacement Of Carbon Filter
If carbon filter does not fit in completely, it 3.1 Replacement of Carbon Filter might drop and damage your product. In environments without flue, active carbon filter 3.3 Replacement of AF 100 Carbon must be used for filtering the air and resending Filter it in. -
Page 10: Cleaning And Preventive Maintenance
appliance, with a damp cloth as well. 4 CLEANING AND PREVENTI- ■ You can clean the metal grease filters in the VE MAINTENANCE dishwasher or by hand. ATTENTION 4.1 Washing in Dishwasher ■ Prior to each maintenance and cleaning, ■ In case of washing in dishwasher, a slight cooker hood must be unplugged, and appliance change might occur in colour. -
Page 11: Installation Of Appliance
5 INSTALLATION OF APPLIANCE Min.65 cm Min.75 cm Fig. 7: INSTALLATION OF APPLIANCE After completing the installation of cooker hood, the minimum distance must be 650 mm between the product and any electric cooker; and 750 mm between it and any gas ranges or cookers burning other fuels. -
Page 12: Exhaust Air Mode
5.3 Exhaust Air Mode 5.5 Checking the Wall WARNING ■ Wall must be flat, straight and have the suffi- cient bearing capacity. Death Risk! ■ Depth of drilling holes must comply with the Exhaust gases that are reabsorbed might lead to length of bolts. -
Page 13: Overview Of Appliance
6 OVERVIEW OF APPLIANCE Fig. 9: OVERVIEW OF COOKER HOOD 1. Front Panel 2. Key 3. Filter 4. Lighting... -
Page 14: Assembly Of Product
7 ASSEMBLY OF PRODUCT Drilling the Hanger Holes end of the p�pe to the flue hole on Make holes with Ø4 mm diameter on the points the wall.F�gure 5 marked as A, B, C, D on the mounting scheme. F�gure 4 The appliance should be mounted on the cab- inet on the points A, B, C, D by using 4 x 40 screws provided with the appliance. -
Page 15: Use Of Product
2- Press this button when you want to operate 8 USE OF PRODUCT the product in speed 2. 3 Spd Rocker Switch 3- Press this button when you want to operate Lamp Switch the product in speed 3. Turn the switch to lamp position to 4- Press this button when you want to turn on turn on the light of the appliance. - Page 16 5 Spd Dgt Switch Cleaning Periods of the Filters: The filters must be cleaned when " " signal ap- pears on the display or (depending on usage) after every 2-3 weeks. When the filters are cleaned and mounted in their places, press but- ton for more than 3 seconds in order to delete "...
-
Page 17: Replacement Of Lamps
Remove the aluminium cartridge filter. Remove 9 REPLACEMENT OF LAMPS the faulty bulb and replace with a new one with the same rating.Fig. 14 DANGER Disconnect the electrical supply of the cooker 9.3 1W Replacement of LED Lamp hood. Leave the lamps to cool down first be- cause they could burn your hands when they are hot. -
Page 18: Authorized Technical Service
10 AUTHORIZED TECHNICAL SERVICE If Lighting is Not Functioning: ■ Make sure that the plug is plugged in, and that the fuses are intact. ■ Check the bulbs. Make sure you unplugged the device before performing this check. Tighten the bulbs if they are loose;... -
Page 19: Potential Failures And Solutions
10.1 Potential Failures and Solutions Description of Failure Reason Help Mains voltage must be 220-240 V, and Check the power Appliance Does Not Work. product must be plugged into a grounded connection. socket. Mains voltage must be 220-240 V, and Lighting Lamp Does Not Check the power product must be plugged into a grounded... - Page 20 MALLOCA VIETNAM COMPANY LIMITED Showroom: 279 Nguyen Van Troi Street, Ward 10, Phu Nhuan District, HCM City Tel: (84) 28 39975 893 / 94 Fax: (84) 28 38447 102 Email: info@malloca.com Customer Care: Hotline: 1800 12 12 Email: chamsockh@malloca.com...
Need help?
Do you have a question about the K1506 and is the answer not in the manual?
Questions and answers