Setting U Pscsi Devices - Adaptec 29160 Manual

Computers may have vertical or horizontal expansion slots. Refer
to your computer manual to locate the PCI slots. If your com-
puter is a tower model, lay it on its side to make it easier to install
the Adaptec SCSI Card 29160.
W
ARNING
29160 in a PCI slot. Some 32-bit slots will not accommodate
it, and the card may break if you force it into the slot.
Insert the Adaptec SCSI Card 29160 into the PCI expansion slot;
S 4
TEP
press down firmly until the card clicks into place, then replace the
slot cover screw. When installed properly, the card should appear
level with the expansion slot, as shown below.
S U
ETTING
There are several things you may need to do to your SCSI devices
before you connect them to the Adaptec SCSI Card 29160:
•
Check the SCSI IDs
•
Set the termination
•
Connect the power cables.
Since setup can vary from device to device, always refer to the
device's documentation for specific instructions.
Below are some guidelines for setting SCSI IDs and termination
on your devices. Refer to the Adaptec SCSI Card 29160 User's Ref-
erence for more information on these topics.
Be careful when inserting the Adaptec SCSI Card
SCSI D
P EVICES
4