Using The Voice Recognition (Vr) Features - Motorola IHF1700Music Motomanual

Using the Voice Recognition (VR) Features

A press and release of the Multi-Function button will activate a voice recognition session.
When you begin a VR session, you hear a prompt and then a short beep. This short beep -
also known as a listening prompt - indicates that the handsfree system is waiting for a verbal
command from you.
The voice recognition handsfree system has 3 main menus -
•
Setup menu – Always available except when in a call.
•
Phone menu – Only available when a handset device is connected.
•
Call menu – Only available when a call is active.
Depending on which menu you are in, saying the predefined commands will allow you to
operate the handsfree system.
The handsfree system includes help prompts in every menu. While learning to use the
handsfree system, or whenever you need a reminder of the command list, say "Help". Some
menus have "Additional Help".
You can say "Repeat" whenever you are prompted for a Yes or No command. The handsfree
system will repeat the question.
Tip: A press and release of the Multi-Function button during a VR prompt will immediately
stop the VR prompt and go the listening prompt.
You can say "Cancel" to return to the last voice recognition menu.
You can say "Exit" to exit the voice recognition session.
Or use the UIM: A press and release of the End button will also exit the voice recognition
session.
Note: Any system prompts enclosed in {} represent prompts that are suppressed in Expert
Mode.
Adjusting the Voice Recognition Volume
At any time except when in a call, the voice recognition's menu volume can be adjusted using
the Volume Up/Down buttons.
Press and release a Volume Up/Down button to increase/decrease the voice recognition
volume by a single level
Press and hold a Volume Up/Down button to increase/decrease the voice recognition
volume rapidly.
Tones are played to indicate when the maximum and minimum volumes are reached.