Overhead Rigging - JB Systems STRIKER Operation Manual

ENGLISH

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any
flammable materials and/or liquids. The fixture must be fixed at
least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside
areas where persons may walk by or be seated.
 Before rigging make sure that the installation area can hold a
minimum point load of 10times the device's weight.
 Always use a certified safety cable that can hold 12 times the
weight of the device when installing the unit. This secondary
safety attachment should be installed in a way that no part of the
installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is
dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in
overheating.
 The operator has to make sure that the safety-relating and
machine-technical installations are approved by an expert before
using them for the first time. The installations should be inspected
every year by a skilled person to be sure that safety is still
optimal.
HOW TO SET UP THE UNIT
FRONT + BACK PANEL:
1. [MIC]: microphone for sound mode
2. [GAIN]: trimmer to adjust the sensitivity of the microphone (1) by use of a small screwdriver
3. [MENU]: press this button to go back to the main menu or to leave submenus.
4. [▼] button : press this button to go down in the menu
5. [▲] button : press this button to go up in the menu
6. [ENTER]: press this button to confirm the selected function in the menu
7. [DISPLAY]: shows the information on the different modes and functions.
8. [DMX IN]: 3p XLR Male connector to receive DMX data from a console or use in Master/slave mode.
9. M-DMX INPUT: Please note that this USB-connector is NOT used for updates or to connect the unit to a
PC! Instead this USB-connector makes it very easy to add wireless DMX to the unit! Just add the
(optional) WTR-DMX DONGLE from BRITEQ
to connect other DMX-controlled equipment to the DMX-output so you can share the wireless DMX
function with all connected units! No extra settings to be made in the setup menu, just follow the
®
JB SYSTEMS
®
and you will get wireless DMX! Moreover you will be able
3/10
USER MANUAL
STRIKER