Setting The Day/Time; Setting Auto Talk - Radio Shack 900 MHz Owner's Manual

43-749.fm Page 13 Tuesday, September 5, 2000 11:24 AM

SETTING THE DAY/TIME

You must set the day of the week and time
so the answering system can record the cor-
rect day and time of each message.
REPEAT
Note: Enter each key press within about 2
minutes. Otherwise, the answering system
exits the time setting process and you must
begin again with Step 1.
1. Hold down
CLOCK
system beeps. The answering system
announces the currently set day of the
week and displays the day's number (0
for Sunday, 1 for Monday, and so on).
2. To change the day, repeatedly press
to move forward or
SKIP
move backward until the correct day
appears, then press
answering system announces the hour.
3. To change the hour, repeatedly press
or until the correct hour
SKIP REPEAT
appears, then press
answering system announces the min-
utes.
4. To change the minutes, repeatedly
press or
SKIP REPEAT
minutes appear, then press
answering system announces "AM" or
"PM," and A or P appears.
To check the day and time, press
The answering system announces the cur-
rently set day and time.
Note: If power fails, the clock retains the cur-
rent time. When the power is restored, it
starts counting again from the time the power
failed.

SETTING AUTO TALK

SKIP
CLOCK
Your phone is preset so you must press
TALK
on, you can answer a call by lifting the hand-
set from the base, or, if the handset is away
from the base, by pressing any key.
Follow these steps to turn auto talk on or off.
until the answering
to
REPEAT
. The
CLOCK
. The
CLOCK
until the correct
. The
CLOCK
Installation
5. Press or
SKIP REPEAT
setting, then press
CLOCK
ing system beeps and announces the
day and time.
to answer a call. With auto talk turned
1. Lift the handset and press
The Caller ID setup menu appears on
the display with Auto Talk
2. Press to change the auto
CH/SELECT
talk setting. On or Off
ing the selected setting.
3. To clear the display when you finish,
press or return the handset to
FUNCTION
the base.
CH SELECT FUNCTION
to change this
. The answer-
.
CLOCK
.
FUNCTION
selected.
appears indicat-
DELETE
VOL/CID
13