Adjusting The Handset Volume; Selecting The Channel; Answering Calls With The Speakerphone - Radio Shack 900 MHz Owner's Manual

43-749.fm Page 15 Tuesday, September 5, 2000 11:24 AM
TALK
When you receive a call,
appears on the display. To answer it, lift the
handset from the base and press
auto talk is on, just lift the handset from the
base or press any key.
To end a call, place the handset on the base
or press .
TALK
ADJUSTING THE HANDSET
VOLUME
To adjust the volume you hear through the
handset during a call, press
9 9 9 9
increase or to decrease the volume. The
display shows Volume Maximum
ume High , Volume Medium
.
ume Low
Note: When you press
VOL/CID
volume is maximum or
VOL/CID
volume is low, the setting does not change.

SELECTING THE CHANNEL

The phone scans 20 channels (frequency
pairs used between the base and the hand-
set) and automatically selects a clear chan-
nel each time you make or receive a call.
If you hear other conversations or excessive
noise during a call, press
lect a different channel. The display shows
Scanning .
Note: If the handset is too far from the base,
the channel might not change. Move closer
to the base and try again.
ANSWERING CALLS WITH
THE SPEAKERPHONE
To answer a call using the speakerphone,
press
lights.
Incoming Call
. If
TALK
To adjust the speakerphone's volume, re-
peatedly press
base. The volume setting from
10
counter window.
8 8 8 8
to
VOL/CID
, Vol-
, or Vol-
8 8 8 8
while the
9 9 9 9
while the
To end a speakerphone call, press
again.
to se-
CH/SELECT
Telephone Operation
. The SPEAKER indicator
SPEAKER
8 8 8 8
VOLUME
(highest) appears in the message
VOLUME
SPEAKER
9 9 9 9
or on the
1 (lowest) to
SPEAKER
15