Freewing FJ211 User Manual page 7

Landing gear Installation Instructions
Nose landing gear Assembly
Please refer to the following diagram to assemble, replace or revise the nose landing gear.
sparepart name and parameters
A- Grub screws (M3x3 1 pcs)
B- Wheel lock
C- Wheel
D- Nose gear main strut
E- Steering arm tiller
F- Grub screw (M3x3)
G- Nose gear steering ring
\
Step8
\
\
Nose steering pushrod size
I----- 65mm --+-I
(2-9/16")
� Note: Ensure that the flat side of the gear shaft is facing towards the screw hole before tightening the grub screw in order to ensure that
the gear is both anchored and facing in the proper direction. Failure to do so may result in the the gear coming loose and falling off.
F-16 Fighting Falcon
lten No.: FJ211
Version No.: FJ211-V01
H- Nose gear steering rod
I - Metal trunion
J -C clip (02.0mm 1 pc)
K- Servo plastic cover(left)
L - Servo plastic cover(right)
M- Screw (PA1.7x8 2pcs)
M1 - Screw (PB1.0x10 3pcs)
StepQ
StepG,
Pushrod diameter: 01.2mm �O
�
N-Screw
0- Nose gear metal reinforcement plate.
P - Assembled Nose gear
Q-Servo
R-Screw
S-Steering push rod
T- Nose gear cover
J·---
Step@
Servo pushrod installing hole
-;::·
i=--...,
S.'E':SLJ aaa;a aa;aca ael
�gp'
(KA2.6x12 4pcs)
(PWA2.0x8 2pcs)
Step@)
Step(i)
= · =
o �
EN