Electrical Connection - Zanussi ZWG 580 E User Manual

35°
The other end of the inlet hose which con-
nects to the appliance can be turned as
showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap. Set the
hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:

Electrical connection

Caution! Any electrical work required
to install this appliance must be car-
ried out by certified Service Centre.
Information on the electrical connection is given
on the rating plate on the inner edge of the ap-
pliance door.
Check that your domestic electrical installation
can take the maximum load required, also tak-
ing into account any other appliances in use.
22
Connect the hose to
a tap with a 3/4"
thread. Always use
the hose supplied
with the appliance.
45°
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90
cm. The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside di-
ameter of the drain hose. The drain hose must
not be kinked.
Caution! Connect the machine to an
earthed socket.
Caution! The manufacturer does not
accept any responsibility for damage
or injury through failure to comply with
the above safety precaution.
Caution! The power supply cable
must be easily accessible after
installing the machine.
Hooked over the
edge of a sink us-
ing the plastic
hose guide sup-
plied with the ma-
chine.
www.zanussi.com