Page 1
GND+Vs RS-485 RS-232 (10 ~ 30 V Power Supply 2. Install the (t)RFU-2400 Configuration Utility (Option) CD: \Napdos\RF_Modem\Utility http://ftp.icpdas.com/pub/cd/usbcd/napdos/rf_modem/utility ICP DAS, RFU-2400 Quick Start Guide, Version 1.0 Page 1 Copyright @ 2016 by ICP DAS Co., Ltd. All Rights Reserved.
Page 2
2480 The “RF Channel” parameter specifies the actual radio frequency channel to be used by the RFU-2400 module, and must be set to the same channel if the module is in the same communication group as other RFU-2400 modules. Channel Selection: As the 2.4 GHz ISM band is a globally available frequency range, a significant...
Page 3
WLAN (IEEE 802.11b/g) standard, and illustrates the relationship between the WiFi and the ZigBee channels. This can be used to give an indication of the most suitable channel that can be selected for use by the RFU-2400. ICP DAS, RFU-2400 Quick Start Guide, Version 1.0 Page 3 Copyright @ 2016 by ICP DAS Co., Ltd.
Page 4
0x000F The “Group ID” parameter specifies the logical group identity for RFU-2400 devices, and each RFU-2400 module must be set to the same value if it is in the same group as other modules. ※ Reminder: When attempting to differentiate between different communication groups, the first priority is to adjust the RF Channel.
Page 5
Two configuration modes can be used, as described below. Hardware Configuration (HW_Cfg) Typically, each RFU-2400 module will be configured using the device hardware, based on the positions of both the Rotary Switch and the DIP Switches, and this normally applies in the majority of cases.
RF Power. Configuration Steps Step 1. Move the INIT DIP Switch on the RFU-2400 to the ON position and then reboot the device. Step 2. Start the configuration utility for the RFU-2400 device and then select the relevant COM port to establish a connection with the device.
Page 7
□ □ DIP 7 ■ ■ Config. Mode DIP 8 Hardware Config. Hardware Config. □ □ Off:□ On:■ Notes ICP DAS, RFU-2400 Quick Start Guide, Version 1.0 Page 7 Copyright @ 2016 by ICP DAS Co., Ltd. All Rights Reserved.
Debug Mode using the procedure described below. Move the INIT DIP Switch on both RFU-2400 devices to the OFF position Move DIP Switches 5, 6 and 7 on both RFU-2400 devices to the ON position and reboot the devices. RFU-2400...