Advertisement
6
Communication Verification
The RFU-2400 can be used once the configuration has been completed. However, if a
failure occurs in the wireless communication, use the following procedure to analyze
the status of the communication in order to determine the source of the problem.
(1) Configure the RFU-2400 devices
Before beginning an analysis of the communication status, first set both the RFU-2400
device that is acting as the monitoring target and the device connected to the Host PC to
Debug Mode using the procedure described below.
-
Move the INIT DIP Switch on both RFU-2400 devices to the OFF position
-
Move DIP Switches 5, 6 and 7 on both RFU-2400 devices to the ON position and
reboot the devices.
OFF
RFU-2400
RFU-2400
(2) Start the configuration utility for the RFU-2400
(3) View the test results for the Received Signal Strength Indicator (RSSI) and
Success Rate. For more details regarding the "Communication Verification",
refer to user manual of RFU-2400.
ICP DAS, RFU-2400 Quick Start Guide, Version 1.0
Copyright @ 2016 by ICP DAS Co., Ltd. All Rights Reserved.
RFU-2400
COM Port Selection
Communication Test
RFU-2400
RFU-2400
Page 8
Advertisement
