Code Entry; Direct Code Entry; Code Search - Zenith ZRF1 User Manual

Code Entry

Direct Code Entry

1. Press and hold the

CODE SEARCH

red indicator stays on, then release the
button.
SEARCH
2. Press and release the desired mode button (
etc.). The red indicator blinks, then stays lit.
3. Enter the 3 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator flashes.
4. With your device on, press
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
CODE
SEARCH
1.
SAT
VCR
TV
2.
CHAN
PAGE
REPEAT
PAGE
FLASHBK
CHAN
SIGNAL
RATIO SURF
INPUT
1 2
3.
4 5
7 8
Write your codes down here for easy reference later.
Type Type stored
TV TV
VCR
SAT 363
DVD
12
button until the
CODE
, ,
TV VCR
. If the
CHANNEL UP
POWER
DVD
AUX
SUBTITLE
DATE
HELP SD/HD
3
6
9
Code
Code Entry, cont.
Programming with Code Search
If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Manually turn on the device (
controlled.
2. Press and hold the
CODE SEARCH
red indicator stays on, then release the
button.
SEARCH
3. Press and quickly release the desired mode button
( , , etc.). The red indicator blinks off once.
TV VCR
4. Press the button repeatedly (up to 300
CHANNEL UP
times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the
to backtrack through the library until the device
changes channel. Pressing
direction to forward again.
5. Press and release to install the code.
MUTE
Most users will store codes under the
VCR
DVD codes under , etc. If (for example) you want to
DVD
store a code under
VCR
DVD
for Direct Code Entry (page 12) and press
of Direct Code Entry, then enter ANY VCR code in step 3
of Direct Code Entry. Then follow the steps above for
Code Search (or Brand Search, next page).
Note: If the device does not have a
button, use ( only) or
VCR
PLAY
Search starts from the currently stored three digit
number under that mode.
CODE
SEARCH
2.
SAT
VCR
TV
3.
CHAN
PAGE
REPEAT
PAGE
FLASHBK
CHAN
RATIO SURF SIGNAL
INPUT
1 2
4 5
13
, , etc.) to be
TV VCR
button until the
CODE
button
CHANNEL DOWN
changes
CHANNEL UP
button,
VCR
, first follow the procedure
in step 2
DVD
CHANNEL UP
instead. Code
POWER
POWER
DVD
AUX
4.
5.
SUBTITLE
DATE
HELP SD/HD
3
6