Table of Contents
Advertisement
Advanced Functions, cont.
DVD Functions
SCAN+ and SCAN- buttons control the speed of Fast
Forward and Reverse Playback respectively.
SKIP+ and SKIP- buttons respectively locate the
succeeding or preceding Chapters or Tracks on a disc.
SUBTITLE button turns the subtitles on or off.
REPEAT button performs DVD players "A-B Repeat" (or
RPT A.B) function for repeat play of current Chapter or
Track.
MENU brings up the DVD disc Menu screen - use with
the UP, DOWN, LEFT & RIGHT navigation buttons.
OK button is used for on-screen Menu selection. Note
some DVD players require the PLAY button to be used.
EXIT button is used to Exit or Clear on-screen Menu
displays.
PLAY button is used to start Disc playback and for
Menu selection on some DVD players.
STOP button stops Disc playback.
PAUSE button pauses Disc playback - press PLAY to
resume.
INPUT (SIGNAL INPUT) activates the DVD Player's
SETUP Menu.
10
Advanced Functions, cont.
VCR/DVD Punch Through Feature
This remote lets you Punch-through to the last VCR or
DVD device used. Normally other types of remotes only
punch-through (from another Mode) on the 6 VCR
buttons, to the device programmed under the VCR
Mode button. This is not much use if you are using a
DVD programmed under a Mode other than VCR. This
remote punches-through to the last VCR or DVD device
you used. For example, if you have 3 DVD/VCR devices
programmed into this remote, the last one you accessed
on the remote will be the one that has control of the 6
VCR/DVD buttons when in any other mode.
TV/VCR/INPUT
When in TV mode the SIGNAL/INPUT button performs
the INPUT source switch function.
When in a mode that has been programmed for VCR the
SIGNAL/INPUT button performs the TV/VCR antenna
switch function.
When in a mode that has been programmed for Cable the
SIGNAL/INPUT button performs the A.B switch
function.
When in a mode that has been programmed for SAT the
SIGNAL/INPUT button performs the TV/SAT switch
function.
When in a mode that has been programmed for DVD the
SIGNAL/INPUT button performs the DVD Setup
function.
TV/VCR and TV/DVD Combo units
Note that for some TV/VCR and TV/DVD combo units
you might need to set up two different buttons to
control both parts of the combo unit. E.G., (referring to
the Direct Code Entry section on the following page)
you might need to set up a code under the TV button to
control the TV part of the combo unit AND a separate
code for the VCR or DVD under any other button you
choose.
11
Advertisement
Table of Contents
