STRIKEMASTER Lithium 40v Owner's Manual page 5

OPERATION
CHECKING BATTERY CAPACITY
NOTE : The battery is not shipped fully charged. It is recommended to fully charge before first use to ensure that
maximum run time can be achieved. This lithium-ion battery will not develop a memory and may be charged
at any time. A fully discharged Battery will require approximately 150 minutes to fully charge from a discharged
state.
Press the Battery Capacity Indicator (BCI) Button. The lights will illuminate according to the batteries capacity level
as shown below.
BATTERY CAPACITY
INDICATOR (BCI) BUTTON
LIGHTS
4 Green Lights
3 Green Lights
2 Green Lights
1 Green Lights
Lights Go Out
BATTERY PROTECTION FEATURES
40v lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize
battery life.
CHARGING THE BATTERY
Batteries are shipped in a low charge condition to prevent possible problems. Therefore, you should
charge prior to first use. If the charger does not charge the Battery under normal circumstances, return
both the battery and charger to your nearest Authorized Service Center for electrical check.
• Charge the Battery only with the recommended charger.
• Connect the Charging Base to a power supply.
• For approved power sources, refer to the operator's manual for the charger.
• Make sure the Battery is secured in the Charging Base before beginning operation.
• Press down on the Battery to be sure contacts on the Battery engage properly with contacts in the
Charging Base.
• The Battery may become slightly warm to the touch while charging. This is normal and does not
indicate a problem.
• Do not place the Charging Base and Battery in an area of extreme heat or cold. They will work
best at normal room temperature.
• When batteries become fully charged, unplug the Charging Base from the power supply and
remove the Battery.
EXTREME COLD WEATHER OPERATION
The Lithium-Ion Battery can be used in temperatures down to (-4°F/ -20°C). If your Battery is not performing correctly, put
the Battery on the Powerhead, free spin auger out and above ice for 30 to 90 seconds depending on how cold the unit is (the
colder the unit, the more time to warm up). After this sequence the Battery will warm up and begin operating normally.
NOTE: Always store Battery in a warm location.
LIGHT METER
CAPACITY
Full Capacity
75% Capacity
50% Capacity
25% Capacity
Requires Charging Soon
Less than 10% Capacity
Requires Immediate Charging
06
MAINTENANCE
WARNING
To avoid personal injury, always remove the Battery from the Auger when cleaning or performing any maintenance.
WARNING
When servicing use only identical StrikeMaster replacement parts. Use of any other parts may create a hazard or
cause product damage.
GENERAL MAINTENANCE
• Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Keep the air vents free of
obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the air vents in water.
• Wipe off the housing and the plastic components using a dry, soft cloth. Do not use strong solvents or
detergents on the plastic housing or plastic components. Certain household cleaners may cause damage and
may cause a shock hazard.
STORAGE
• Always remove the Battery before storing the Charging Base or any time the Charging Base is unplugged.
• Do not place the Battery in the sun or in extremely warm environment. Keep at normal room temperature.
• If the battery will not be used for 6 months or more, please store the battery in a room temperature environment.
Please fully charge before storage.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. to come in contact
with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
The Battery charge is reduced The Battery has automatically
after more than one month performed self-maintenance
of non-use to extend its life
REMEDY/ACTION
Fully recharge the battery before use
07