STRIKEMASTER Lithium 40v Owner's Manual page 16

STRIKEMASTER LITHIUM 40v BATTERY CHARGING BASE
®
QUICK START
1. Remove Lithium 40v Battery Charging Base from carton (Image 1). Plug in.
2. Unpack Battery, slide Battery onto Battery Charging Base using the channels on both
sides as a guide. Press down until you hear it click in place. Leave Battery on Battery
Charging Base until fully charged.
NOTE: Battery is not fully charged when fi rst removed from box.
3. When Battery Charging Base indicator shows green, your Battery is
fully charged (Image 3).
Your StrikeMaster Lithium 40v Battery is ready for use.
Your StrikeMaster Lithium 40v Battery Charging Base has built in "Smart Charging
Technology". The chart below shows you the correct charging procedure/occurrences
that could be experienced while charging.
SAFETY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS DANGER – TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE INSTRUCTIONS
Read and understand all instructions before using this product. Failure to follow all instructions
listed below may result in electric shock, fi re, and/or serious personal injury.
W A R N I N G
IMAGE 1
FOR INDOOR USE ONLY
C A U T I O N
RISK OF ELECTRIC SHOCK. DRY LOCATION USE ONLY.
Store Indoors and do not expose to rain or water. Avoid direct sunshine.
C A U T I O N
RISK OF FIRE OR ELECTRIC SHOCK, DO NOT INTERCONNECT OUTPUT TERMINATIONS
C A U T I O N
CHARGE ONLY RECHARGEABLE LI-ION BATTERY PACK LFV-B/LFV-BEU, OTHER TYPES OF BATTERIES MAY
BURST CAUSING PERSONAL INJURY AND DAMAGE
D A N G E R
RISK OF ELECTRIC SHOCK. DO NOT TOUCH UNINSULATED PORTION OF OUTPUT CONNECTOR OR
UNINSULATED BATTERY TERMINAL
SAVE THESE INSTRUCTIONS
• This manual contains important safety and operating instructions for Battery Charging Base LFV-CB.
• Before using Battery Charging base, read all instructions and cautionary markings on Battery Charging Base,
Battery and StrikeMaster Lithium 40v Ice Auger.
• To reduce the risk of fi re and electric shock, install in a temperature- and humidity-controlled indoor area
relatively free of conductive contaminants.
• Use of an attachment not recommended or sold by Battery Charging Base manufacturer may result in a risk of
fi re, electric shock, or injury to persons.
• Following this rule will reduce the risk of electric shock, fi re, or serious personal injury.
• Do not abuse cord or Charging Base. Never use the cord to carry the Charging Base. Do not pull the charger
cord rather than the plug when disconnecting from electrical outlet. Damage to the cord or charger could occur
and create an electric shock hazard. Bring to an authorized service center if cords are damaged.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take
it to an authorized service center for electrical check to determine if the charger is in good working order.
• Do not cover the ventilation slots on the top of the charger. Do not set the charger on a soft surface i.e. blanket,
pillow. Keep the ventilation slots of the charger clear.
• Do not probe the charger with conductive materials.
• Do not disassemble Charging Base. Take it to an authorized service center when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fi re.
• Disconnect Charging Base from the power supply when not in use. This will reduce the risk of electric shock
or damage to the charger if metal items should fall into the opening. It also will help prevent damage to the
Charging Base during a power surge.
• Do not use a damp cloth or detergent to clean the Battery or Charging Base. Clean / wipe down with a dry cloth.
• Do not allow the battery pack or charger to overheat. If they are warm, allow them to cool down. Recharge
only at room temperature.