Audio Technica AT-LP5 Installation And Operation Manual page 18

Duplicate - Makes a copy of all or a part of a track or set of tracks into new
tracks. See the figure below:
Select ... > All - Selects all of the audio in all of the tracks in the project.
Select ... > Start to Cursor - Selects from the beginning of the selected
tracks to the cursor position.
Select ... > Cursor to End - Selects from the cursor position to the end of
the selected tracks.
Find Zero Crossings - Modifies the selection slightly so that both the left
and right edge of the selection appear on a positive-slope zero crossing.
This makes it easier to cut and paste audio without resulting in an audible
clicking sound.
Selection Save - Remembers the current selection (or cursor position),
allowing you to restore it later.
Selection Restore - Restores the cursor position to the last position saved
by "Selection Save".
Move Cursor ... > to Track Start - Moves the cursor to the start of the
current track.
Move Cursor ... > to Track End - Move the cursor to the end of the
currently selected track.
Move Cursor ... > to Selection Start - Moves the cursor to the start of the
current selection.
Move Cursor ... > to Selection End - Moves the cursor to the end of the
current selection.
Snap-To ... > Snap On - Enable Snap-To mode. When Snap-To mode is
enabled, the selection will be constrained to the nearest interval on the
time scale, by default the nearest second. So if you click and drag from 4.2
seconds to 9.8 seconds, it will result in a selection from 4 seconds to 10
9