How To Send The Data Out From The Meter - Lutron Electronics TM-925 Operation Manual

6. HOW TO SEND THE DATA OUT
1)To send the data out from the meter, cancel the
" Hold function " and the " Record function " first.
2)Press the " Send Button " ( 3-2, Fig. 1 ) at least 5
seconds until the lower display show " r232 ", then
release the button.
3)Push the " Send Button " ( 3-2, Fig. 1 ) once, the lower
display will show " SEnd ", the upper no. will count up
until reach the data logger storage no., at the same
the storage data logger data will send out the meter
from the " RS-232 output terminal " ( 3-9, Fig. 1 ).
4)If intend up load the data to the computer, then
should connect the optional RS232 cable/UPCB-01 or
USB cable/USB-01 and cooperate the Data Logger
software ( optional, Model : SW-DL2005 ).
5)Press the " Send quit button " ( 3-3, Fig. 1 ) will
escape the data sending function.
108
r232
0
SEnd
14
The total data logger
no. that saved into
the memory.
Count up from 0 to
the data logger
storage no.