Data Hold; Data Record (Max, Min Reading) - Lutron Electronics TM-925 Operation Manual

4)Press the " Function button " ( 3-3, Fig. 1 )
continuously until the LCD show the " T1-T2 " symbol
then release the finger from the button, the upper
display will show the T1-T2 temperature reading, the
lower display will show the T1 temperature reading.
K
Note :
1) If intend to change the measuring unit from
refer section 5-2, page 12.
2) If intend to change the measuring function from type K to type J,
refer section 5-1, page 12.

4-3 Data Hold

During the measurement, press the " Hold Button " ( 3-3,
Fig. 1 ) once will hold the measured value & the LCD will
display a " HOLD " symbol.
* Press the " Hold Button " once again will release the data
hold function.
4-4 Data Record ( Max., Min. reading )
* The data record function records the maximum and
minimum readings. Press the " REC Button " ( 3-4, Fig.
1 ) once to start the Data Record function and there
will be a " REC " symbol on the display.
T1-T2
1.2
℃
28.6
8
T1-T2 temperature
T1 temperature
to ,
℃ ℉