Intel Ethernet X520 10GbE Dual Port KX4 Mezz User Manual page 127

Event Message
ID
53 Jumbo Frames cannot be configured when MACSec is enabled.
NOTE: This message is used only for the following adapters:
Intel® Gigabit 2P I350-t Adapter
l
Intel® Gigabit 4P I350-t Adapter
l
Intel® Gigabit 4P I350-t rNDC
l
Intel® Gigabit 4P I350-t Mezz
l
Intel® Gigabit 2P I350 LOM
l
Intel® Gigabit 2P I350-t LOM
l
54 PROBLEM: A malicious VF driver has been detected.
55 The value of NumVFs exceeds the maximum value allowed by the driver in the current con-
figuration. The value will be set to the maximum allowed.
Below is a list of Intel network adapter custom event messages that appear in the Windows Event Log for the Intel 10
Gigabit adapters:
Event Message
ID
6 PROBLEM: Unable to allocate the map registers necessary for operation.
ACTION: Reduce the number of transmit descriptors and restart.
7 PROBLEM: Could not assign an interrupt for the network adapter.
ACTION: Try another PCI slot.
ACTION: Install the latest driver from
tel.com/support/go/network/adapter/home.htm
23 PROBLEM: The EEPROM on the network adapter may be corrupt.
ACTION: Visit the support web site at
tel.com/support/go/network/adapter/home.htm
24 PROBLEM: Unable to start the network adapter.
ACTION: Install the latest driver from
tel.com/support/go/network/adapter/home.htm
25 PROBLEM: The MAC address on the network adapter is invalid.
http://www.intel.com/support/go/network/adapter/home.htm
ACTION: Visit
27 Link has been disconnected.
30 PROBLEM: The network adapter is configured for auto-negotiation but the link partner is not.
This may result in a duplex mismatch.
ACTION: Configure the link partner for auto-negotiation.
31 Network link has been established at 10Gbps full duplex.
32 Network link has been established at 1Gbps full duplex.
33 Network link has been established at 100Mbps full duplex.
34 Network link has been established at 100Mbps half duplex.
35 Network link has been established at 10Mbps full duplex.
36 Network link has been established at 10Mbps half duplex.
37 PROBLEM: PCI Express bandwidth available for this adapter is not sufficient for optimal per-
formance.
ACTION: Move the adapter to a x8 PCI Express slot.
http://www.in-
.
http://www.in-
for assistance for assistance.
http://www.in-
.
Severity
Informational
Warning
Informational
Severity
Error
Error
Error
Error
Error
for assistance.
Warning
Warning
Informational
Informational
Informational
Informational
Informational
Informational
Warning