Figure 2 Internal Lto-3 Tape Drive Jumper Settings - Quantum Tape Drive LTO-3 User Manual

Figure 2 Internal
LTO-3 Tape Drive
Jumper Settings
Table 1 ISCSI IDs
and Jumper Settings
for an Internal LTO-3
Tape Drive
and 7–8 to change the SCSI ID of the LTO-3 Tape Drive (see
table 2), or assign a unique SCSI ID to the other SCSI device.
The SCSI controller or host adapter generally uses ID 7. In
Note:
some systems, the boot drive uses ID 0 or ID 1. Avoid setting
your drive's SCSI ID to these settings.
Drive Configuration Jumpers Pins
Drive Configuration
Default
Settings:
Pins: Function :
1-2 SCSI ID bit 0
3-4 SCSI ID bit 1
5-6 SCSI ID bit 2
7-8 SCSI ID bit 3
9-10 Reserved
11-12 Termination Power
Jumpers
SCSI ID 1–2
0 Open
1 Shunted
LTO-3 Tape Drive User's Guide
Installing an Internal LTO-3 Tape Drive
Jumpers Pins
3–4
Open
Open
Chapter 2 Installation
table 1 and
Jumper Settings
SCSI ID=0
SCSI ID=8
SCSI ID=1
SCSI ID=9
SCSI ID=2
SCSI ID=10
SCSI ID=3
SCSI ID=11
SCSI ID=4
SCSI ID=12
SCSI ID=5
SCSI ID=13
SCSI ID=6
SCSI ID=14
SCSI ID=7
SCSI ID=15
Term. power
5–6 7–8
Open Open
Open Open
9