Quantum Tape Drive LTO-3 User Manual page 79

• is the data under
x
• is the data under I from the
y
• is the tape device identifier number.
z
You can execute an
ls
identifier number that has not already been used. You can also choose a
unique device name such as cnb to more easily remember which device
name will enable data compression during write. Refer to the man pages
for mksf to review settings for r
.
AT&T mode
After performing the
ioscan –fn | grep –C tape
output showing the hardware and device addressing and also the device
name attached to the LTO-3 Tape Drive.
LTO-3 Tape Drive User's Guide
from the
H/WPath ioscan
ioscan .
command for the
/dev/rmt
ewind/no rewind
and commands, use the command
insf mksf
to check the installation. You should see
Chapter 6 UNIX Settings
Configuring for HP-UX 11.0
.
directory to choose an
, , and
Berkeley mode
65