iDect X2i System User Manual page 44

Troubleshooting continue...
"When I press keys on Try moving the Handset closer to the Base unit.
Handset, digits appear
Try a different position for the base unit - perhaps
on the LCD screen, but
higher, or further from other electrical equipment.
I can't make an outside
call."
"The phone does not Check that the Base unit's mains power adapter is
ring." plugged in and power is switched on. The Base unit
needs mains power for normal operation of the phone -
not just for charging the batteries.
Make sure you're using the telephone line cable that
was supplied with your iDECT X2i. Other telephone
line
Check that you have not set the ringer volume to Off.
See Section 4 for more information.
Check that the total REN value of all equipment
connected to your telephone line is no more than 4.
Disconnect one or more telephones and see whether
that helps.
"My call was cut off Move the Handset closer to the Base unit before you try
when I went out of again to make a call.
range. Now I can't
use my handset."
"There is interference, Move the Handset closer to the Base unit, or to a
different position.
noise or echoing on
the line."
Try moving the Base unit so that it's not near other
electrical equipment, such as a TV or a computer.
If you are using a routing box (smart socket), try
disconnecting it then making a call. If the sound is OK
without the routing box, that's the cause of the problem.
You'll get the best results if you site the Base unit as
high as possible. For example, in a two-story house,
the first-floor landing is an ideal place for the base unit.
"When I press the The strange noise is caused by interference. Disconnect
the mains power lead from the back of the Base unit,
PHONE or SPEAKER-
then wait for 30 seconds before reconnecting it.
PHONE button, I hear
a loud noise."
cables might not work.
35