Standing Pilot Ignition System Wiring - Quadra-Fire SAPPHIRE-D-CSB Owner's Manual

C. Standing Pilot Ignition System Wiring
This appliance DOES NOT require 110 VAC supply for
operation. See wiring diagram below.
This appliance is equipped with a millivolt control valve.
Ignitor
ON/OFF
Switch
Figure 7.1
28
Red
28 in. (711mm)
Red
28 in. (711mm)
Quadra-Fire • Sapphire • 7055-116 Rev. D • 6/11
CAUTION
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
CAUTION
Shock hazard.
• Replace damaged wire with type 105
rated wire.
• Wire must have high temperature insulation.
Valve
O C
A E