Integrated Peripherals - Acer Aspire X1301 Service Manual

Integrated Peripherals

Parameter
IDE Function Setup
MCP Storage Config
Init Display First
HD Audio
HDMI Audio
MAC LAN
IDE HDD Block Mode
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
ECPM Mode Use DMA
USB Device Setting
20
Description
Press Enter to access the IDE Function Setup submenu.
Press Enter to access the MCP Storage Config submenu.
Select whether to boot the system using the AGP graphic card or a PCI
card installed on the PCI Express slot or PCI slot.
Enables or disables the onboard audio controller.
Allows you to control the audio function of the onboard HDMI.
Enables or disables the built-in network interface card.
When enabled, the BIOS will automatically detect if your hard disk
supports block transfers and set the proper block transfer settings for it.
Depending on the IDE controller, up to 64 KB of data can be transferred
per interrupt when block transfers are enabled.
When disabled, only 512 bytes of data can be transferred per interrupt.
Select the I/O address and IRQ for the first serial port.
Select the I/O address and IRQ for the onboard parallel port.
Select an operating mode for the onboard parallel port.
Select DMA channel for the LPT port in ECP mode. This parameter can
be configured if the parallel port mode is set to ECP or ECP +EPP
mode.
Press Enter to access the USB Device Setting submenu.
Option
PCIEx
PCI Slot
Onboard
Auto
Disabled
Disabled
Auto
Auto
Disabled
Enabled
Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Auto
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Disabled
SPP
EPP
ECP
ECP+EPP
3
1
Chapter 2