Table of Contents
Advertisement
APPENDIX-
DataPort Pinout
NOTE!
This information is shown for reference only and is subject to change without notice as the DataPort feature is spe-
cific to QSC products and not intended for interface to other manufacturer's equipment.
NOTE!
Powerlight 6.0 and Powerlight 9.0 amplifiers require that pin #9 be removed from the remote mounting interconnect
cable (DPX-2). Amplifier damage may result from use of cable that has pin #9 connections present.
Pin
Signal Description
1
Ch. 1 Minus (-) Input Signal
2
AC Standby Control
3
V- MON Ch. 1 and encode 1
4
I- MON Ch. 1 and encode 2
5
Clip/Protect Ch. 1
6
Hard Ground
7
Ch. 1 Plus (+) Input Signal
8
Ch. 2 Plus (+) Input Signal
9
+15V from Amplifier
10
Data Reference Ground
11
Ch. 2 Minus (-) Input Signal
12
Amplifier IDR (Model ID)
13
V- MON Ch. 2 and encode 3
14
I- MON Ch. 2 and encode 4
15
Clip/Protect Ch. 2
Description of Encode Signals
encode 1
Bridge mode & power detect
encode 2
Temperature, channel 1
encode 3
Standby mode detect
encode 4
Temperature, channel 2
RS-232 PINOUT
Note that Pin #9 is used for Contact Closure function (normally not used in RS-232).
Pin
Signal Description
1
DCD
2
TD
3
RD
4
DTR
5
Signal GND
6
DSR
7
RTS
8
CTS
9
contact closure
19
Advertisement
Table of Contents
