Table of Contents
Advertisement
30. Loosely install the new trailing arm front mounting
bolts.
MOUNTING
BOLTS
31. Loosely install a new flange bolt on the knuckle
and the upper arm.
UPPER
ARM
8 of 9
32. Install the damper mounting bushing onto the
FLANGE
BOLT
33. Install the stabilizer link on the stabilizer bar and
KNUCKLE
34. Install the stabilizer link on the trailing arm with
AII 44382 (1008)
damper unit, and install the damper unit. Slowly
raise the jack until you can align the bolt hole with
the holes in the trailing arm and the damper, then
install the new flange bolt.
trailing arm with the joint pins set at the center of
their range of the movement.
NOTE: Make sure the paint mark on the
stabilizer link faces rearward.
HEX
WRENCH
JOINT PIN
a new self-locking nut, and lightly tighten both
nuts.
© 2010 American Honda Motor Co., Inc. - All Rights Reserved.
BUSHING
DAMPER
STABILIZER
LINK
TRAILING
ARM
FLANGE
NUT
Advertisement
Table of Contents
