Ethernet Settings - Haivision Mantaray Administrator's Manual

Ethernet Settings

On the Ethernet settings page, you can specify the network settings for the STB. By default,
Dynamic Host Configuration Protocol (DHCP) is enabled, which means that the STB will
get an IP Address from a DHCP server on the network. When DHCP is disabled, you must
manually enter an IP Address for the STB, as well as Netmask, Gateway, and DNS server
address(es).
To configure the Ethernet settings:
Using the remote control, press the Down Arrow to scroll down to
1.
Press the Left/Right arrows or
2.
network mode.
If you select Static, fill in the additional network settings that are displayed.
3.
When you have finished, select
4.
Mantaray Administrator's Guide, v1.0.3, Issue 01
button to toggle between DHCP (default) and Static
OK
.
Save
Initial Setup
Configuring Mantaray
.
Ethernet
29