Haivision Mantaray Administrator's Manual page 25

IMPORTANT
and time must be set before the Electronic Program Guide (EPG) will work.
If your network supports DHCP, you can skip to
5.
default.)
To specify the IP address or other network settings for the STB, press the Up Arrow
6.
on the remote control to scroll up to
Select Static, fill in the required addresses, and click
Settings"
Use the remote control to scroll down to
7.
Enter the IP of the Furnace and the corresponding port number. Click
see "Server Setup"
Wait until the STB application downloads and installs all necessary files from the
8.
Furnace server. If there is a new software version, it will reboot. This may take a
minute.
When the STB display opens again, it tunes to the first channel and begins playing
audio and video.
To display the Electronic Programming Guide, press the
9.
control. The content displayed is based on the Furnace lineup.
Administrators can use the
TIP
Mantaray
manage
For example, you can edit device information, remove devices, and send control
commands such as mute/unmute, reboot, set PIN/channel/volume, and power On/Off.
For more information, see the
Mantaray Administrator's Guide, v1.0.3, Issue 01
By default the Mantaray's date and time is 1 Jan 1970. The correct date
on page 29.
on page 30.
Furnace
s, either individually or in groups.
Furnace
Administration Guide.
Joining Mantaray to a Furnace
Step #7. (DHCP is enabled by
.
Ethernet
. For details, see
Save
.
Server Setup
button on the remote
EPG
Mantaray
Admin Web Portal (
Initial Setup
"Ethernet
. For details,
Save
Manager) to
25