5.7 Mask Area Setup
In some cases you might want to mask a sensitive area. This area will not be
viewed or recorded. The mask area setup steps are as follows:
Step 1: Enter into "Camera" menu:
Step 2: Select a camera: You can use
Step 3:Enter into "Advanced settings" enable the check box beside "Privacy
Mask", you can press the
activate "Area" button. Move "Active Frame" to "Area" button on the right side of
【
mask check box, press
fig 5.13
Step 4: Setup mask area: In the mask area setup interface, there is one small
yellow panel on the upper left side. For PAL camera, the whole screen is divided into
22*18 panels (22*15 for NTSC), you can use
yellow panel to your desired position and press the
be turned into red, then you can use
【 ← 】
k ey to shrink the red panel. This red area is the mask area.
After you setup the red mask area, press
maximum mask area size is 8*8 panels and the minimum size is only one panel. You
can setup 4 mask areas at most.
QH32DVR4C User's Manual
【 】 【 】
【
E nter
】
o r
【
e dit
】
】
E NTER
key to enter into mask area setup interface shown as
Fig 5.13 Mask area setup
【 ↑ 】 【 ↓ 】 【 → 】 【 ← 】
【 ↑ 】 【 ↓ 】 【 → 】
【
44
k eys to select the camera.
key to change the flag into " ", and
k eys to move the
【
】
E DIT
k ey, the yellow panel will
keys to extend the red panel and
E DIT
】
k ey to save the mask area. The