Ruckus Wireless SmartCell 200 Reference Manual page 12

Wireless gateway s2a interface smartzone 3.4

Hide thumbs Also See for SmartCell 200:

Table of Contents

Figure 1. Deployment of SCG with 3G and EPC

The SCG supports the following categories of GTP signaling traffic:

• Path Management Messages: The main purpose of these messages is to

supervise an UDP/IP path to ensure that connectivity failure can be detected on

time. This is managed by frequently sending GTP Echo or Echo response

packets between SCG and PGW.

• Tunnel Management Messages: These contain messages that establish, modify

and release GTP tunnels.

NOTE:

The SCG support for STA interface is being considered for the future release.

NOTE:

Refer to

SCG™ 200 S2a Interface Reference Guide for SmartZone 3.4, 800-71172-001 Rev A

About This Guide

for the conventions used in this guide.

Data Session and Path Management Messages

Overview

Table of Contents

Need help?

Do you have a question about the SmartCell 200 and is the answer not in the manual?