Software Installation; Starting The Program - Ericsson EF738 Service Manual

Test/Service Programs

Software Installation

The ETACS Service Program consists of four files:
• SPEP1361.EXE
• TYPE1361.CFG
• TYPE1361.EDT
• TYPE1361.MNU
The program can be run directly from a diskette, but it is adviseable to have it run
from the hard disk.
Simply install the software on the hard disk by copying the contents of the diskette
to a suitable directory on the hard disk.
The copying of files mentioned above describes how to install the ETACS Service
Program from a standard floppy disk, but the program may become distributed in
other media formats.
CAUTION!
Use a fully charged phone battery, since the interface is powered by the phone.
Using an even slightly discharged battery may result in misreadings, even if the
Low Battery warning has not yet appeared.

Starting the Program

Turn the phone On.
Start the program by double-clicking the file SPEP1361.EXE in the File Manager /
Explorer, and the following picture appears on the screen:
File
Select the serial port (COM1 or COM2) where the programming interface is con-
nected, as instructed on the screen.
18
Edit Short Numbers
SELECT COM PORT
1 Press digit 1 to use COM1:
2 Press digit 2 to use COM2:
Esc Press ESC to continue.
Options