Ford RANGER 2015 Body And Equipment Mounting Manual page 87

• Re-paint metal edges after cutting or drilling.
All metal edges must comply with exterior and
interior protection legislation.
• All fixings through the floor, sides or roof must
be sealed.
Refer to: 5.4 Corrosion Prevention (page 104).
• Ensure that any additional equipment in the
vicinity of the fuel tank will not damage the
tank in a crash condition.
Body Attachment Holes in Chassis Frame - Single cab
Dimensions (mm) for Body Attachment Holes in Chassis Frame - Single Cab
Dimension
A
B
C
D
E
F
G
FORD RANGER 2015
For any conversion structure attached to or
mounted onto the base vehicle cab structure the
following applies:
• Ensure that neither the conversion structure
nor the existing vehicle structure get
pre-loaded by the assembly process.
• Adhesive jointing is recommended but should
be supplemented with mechanical fasteners
to prevent initial peel and long term failure.
• Spread bolt loads to minimize local stress.
Dimension
16
28
23
20
1244
1244
1244
H
J
K
L
M
N
P
Date of Publication: 02/2017
1086
95
768
893
509
26
20