Choosing A Location; Telephone Setup - PhoneMate PM2420 Installation And Operating Manual

PM2420Manual_En 2005.2.5 1:21 PM ˘ ` 13

CHOOSING A LOCATION

When installing your telephone, consider the following:
The best location:
Near a central location on a level dry surface.
g
Away from microwave ovens
g
Away from VCR's and TV sets and other electronic equipment
g
Away from sources of noise, such as windows opening onto a busy street
g
Away from personal computers
g
Away from excessive moisture, extremely low or extremely high temperatures,
g
dust, mechanical vibration or shock.
The location of your telephone affects the quality of the reception. Consider the following
when choosing a location or if you are experiencing poor reception.
Away from other cordless telephones
g
Place the base near an AC electrical outlet and near a telephone line jack
g
Place the base away from metal walls and metal file cabinets.
g
Try to avoid power bars or multiple appliances plugged into the same electrical
g
outlet
CAUTION: The cordless telephone operates at a frequency that may cause
interference to nearby TV's and VCR's; the base phone should not be placed
near, or on top of a TV or VCR. If interference is experienced, moving the
cordless phone telephone farther away from the TV or VCR will often reduce or
eliminate the interference.
12
AGFA SelectSet Avantra 25

TELEPHONE SETUP

Connecting the Base
1. Connect the telephone line cord to the "TEL LINE" jack and to a telephone outlet.
2. Connect the AC power adapter to the 9V DC jack and to an AC outlet.
Note: : Use only the supplied AC power adapter. Do not use any other AC power adapter.
Connect the AC power adapter to a continuous power supply. Place the phone close to the AC
outlet so that you can plug in the AC power adapter easily.
TIP: If your telephone outlet is not modular, contact your telephone company
for assistance.
Tone/Pulse Switch
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or Pulse by setting the switch at the bottom of the
base unit.
Note: Changes to the switch position during a call do not take effect until the call has ended.
TIP: If you are unsure of the proper dialing mode, make a trial call
with the dial mode setting to TONE. If the call connects, leave
the switch as is (TONE mode), otherwise, set to PULSE.
Handset Ringer Switch
Adjust the handset ringer volume using the RINGER switch on the right side of the
handset. Select between ringer On, or ringer Off.
Model PM2420
13