Table of Contents
Advertisement
ADCP-80-531 • Issue 4 •July 2004
PAINT CUTTING, TAPPING SCREW,
PAN HEAD, COMBINATION DRIVE
3/8-IN.
(9.53 mm)
12 - 24
THREAD
16592-A
Figure 9. Screw for Attaching Bracket to Rack
4.2.3
Screws to Attach Protective Cover to Circuit Breaker Panel
To fasten the plastic protective cover over the power connections, use the four tin plate finish
screws as shown in
Figure
10. Four screws are in the package.
MACHINE SCREW, PAN HEAD,
PHILLIPS DRIVE
3/8-IN.
(9.53 mm)
6 - 32
THREAD
16593-B
Figure 10. Screw for Attaching Protective Cover to Circuit Breaker Panel
4.3
Protective Cover Installation/Removal
To attach the plastic protective cover over the connectors on the rear of the circuit breaker panel,
insert the four screws (defined in
Subsection 4.2.3, Screws to Attach Protective Cover to Circuit
Breaker
Panel) into the standoffs located next to each output power screw-down barrier strip.
Rotate each screw several turns to get it threaded. Hold the cover so the lettering is oriented
properly and then place the cover over the screw heads. Slide the cover to the left and then
tighten the screws to 9 pound-force inches (1 Newton meter).
To remove the protective cover, loosen but do not remove the four screws that secure the cover
to the panel. Slide the cover to the right and then pull the cover directly outward and away from
the panel. The screws do not need to be completely removed to remove the protective cover.
Page 19
© 2006, ADC Telecommunications, Inc.
Advertisement
Table of Contents
