Caution: This equipment employs electrical voltage and amperage levels which may be
considered an electrical hazard. Care should be exercised to assure that only qualified
personnel are allowed to install, operate, maintain, or otherwise come in contact with this
equipment when the circuit breaker panel is energized. Only insulated tools should be used on
energized elements of the circuit breaker panel.
Warning: Never install power equipment in a wet location or during a lightning storm. When
installing or modifying power lines, disconnect lines at the source before working with
uninsulated lines or terminals to prevent electrical shock.
4.1
Recommended Installation Tools
Use common hand tools, such as a Phillips screwdriver, a wire wrap gun and bits, a wire
stripper, and a wire lug crimper to install the circuit breaker panel. In addition to these tools, the
following tools are recommended:
• Power screwdriver with bits for Phillips and slotted head screws
• Set of sockets and driver
• Set of open end or box end wrenches
PHILLIPS SCREW
HEAD BIT
16776-A
12504-A
© 2006, ADC Telecommunications, Inc.
ADCP-80-531 • Issue 4 •July 2004
Page 17