Circuit Breaker Designation Card And Holder; Voltage Designation Label; Material And Finish - ADC PowerWorx Select Series User Manual

ADCP-80-531 • Issue 4 • July 2004

1.12 Circuit Breaker Designation Card and Holder

A circuit breaker designation card as shown in
circuit breaker panel. The card holder is intended to be attached to the underside of the panel,
one of the panel mounting brackets, to a part of the rack in which the panel is installed, or at a
location close to the panel, as desired. The card should be filled out with circuit information for
each of the circuit breakers installed in the panel and inserted in the card holder. The card holder
has a pressure sensitive adhesive backing for attachment.

1.13 Voltage Designation Label

A voltage designation label as shown in
label is intended to be filled out with the actual voltage present on the buses and placed on the
panel. The voltage designation label has a pressure sensitive adhesive backing for attachment.

1.14 Material and Finish

The circuit breaker panel chassis and brackets are made of 16-gauge cold rolled steel. The panel
and brackets are finished with powder paint.
Page 12
© 2006, ADC Telecommunications, Inc.
Figure 4
2.36 IN.
(5.99 CM)
10 POSITION A AND B CARD
Figure 4. Circuit Breaker Designation Card
Figure 5 is provided with the circuit breaker panel. The
0.38 IN.
(0.96 CM)
1.00 IN.
(2.54 CM)
Figure 5. Voltage Designation Label
and a card holder are provided with the
1.60 IN.
(4.06 CM)
16753-A
14228-A