Supermicro SC-830W User Manual page 15

a) A device that you've installed requires the same resource as another device.(For example, a conflict occurs
when two adapters try to write to the same address space.)
b) The serverboard doesn't come with the CPU, if the CPU is PIII 600MHZ, but the maximum allowed for the
serverboard is 500MHZ.
c) The RAM is 66MHZ only, but serverboard needs the PC-100 or PC-133 MHZ type.
You can check all the configurations in the user manual of serverboard to find out the
proper solution of your system.
2. Check the CPU:
a) The CPU is not well plugged into the basic button.
b) The CPU Clock switch is set in an improper position.
c) The slot 1 of the Intel Dual CPU serverboard has to be
plugged into the processor terminator card as you use signal CPU's.
d) Two CPUs on the Intel Dual CPU serverboard have different speeds and frequency.
All conditions mentioned will make the system be halted.
B) Check the RAID system to see if any of the following conditions occurs:
1) A failing SCSI device (adapter, drive, controller)
2) An improper SCSI configuration or an improper SCSI termination jumper
setting.
3) Duplicate SCSI IDs in the same SCSI chain.
4) A missing or improper installation of components in or on the SCSI terminator.
5) A defective SCSI terminator.
6) An improper installed cable.
7) A defective cable.
Page 14