Table of Contents
Advertisement
29. Import/Export
The Import/Export feature is useful for backing up all the 40-IP's programming or for importing programming when
installing multiple units with a majority of the same programming.
30. Clear Speaker Settings
Clicking on the "Clear Speaker Settings" button in programming will reset all of the Programming Features back to their
factory default settings. Note: This command will not change or reset your IP settings or Multicast paging settings.
31. Clear IP Settings
Clicking on the "Clear IP Settings" will reset all of the IP settings back to their factory default settings. This also clears
paging Group settings and Addresses. Note: This will not affect any speaker settings.
32. Night Ring
When Night Ring Timed Operation is enabled, if a SIP call is received during the programmed Start and Stop times, the
40-IP will output loud ring on the "Line Out" and "Speaker Out" terminals. This is selectable for each day of the week.
When outside of the Night Ring timing window, the Inbound Call Mode setting will determine how SIP calls are handled.
NOTE: For timed Night Ringing the unit must be synced with a time server. If the Night Ringing feature is enabled in
the software you will be asked to use Viking Time Server when changes are applied. The address will be entered by
the software automatically.
33. Time Zone Settings
When using the Night Ring Timed Operation the 40-IP must be synced with the network time. Set the Time Zone Settings
to match the settings on the network the unit is connected to for proper timed operation.
16
Advertisement
Table of Contents
