Table of Contents
Advertisement
DESCRIPTION
Connect/Disconnect
Unit Name
Peer to Peer Settings
Alternate Server
Security code (factory set to 845464)
Access Code (1-6 digits, blank = disabled, factory set to 123456)
SIP Page Priority over Multicast Page
Paging Sources
Multicast Paging Volume (0-9, factory set to 1)
External Relay (factory set to External)
Relay Mode (Door Strike, Paging, Alarm, Ring, Ring Flash, factory set to Door Strike)
Relay Activation Command (1 or 2 digits, factory set to QQ) NOTE: Relay Mode must be set to Door Strike
Relay Activation Time (0.5 - 99 sec, factory set to 5 sec)
Relay Buzz Volume (1-3 or Disabled, factory set to 3)
Relay Latch Commands (Enabled or Disabled, factory set to Enabled) NOTE: Relay Mode must be set to Door Strike
SIP Paging Volume (0-9, factory set to 1)
Ring Volume (0-9, factory set to 5)
SIP Page Length Time Out (disabled or 1 to 9 min, factory set to 3 min)
Multicast Page Length Time Out ( 1 to 255 seconds, factory set to 180 seconds)
Inbound Call Mode (Disabled, Auto Answer, Auto Answer-Secure or Ring, factory set to Auto Answer)
Ring Cadence (factory set to Normal, 2 seconds on 4 seconds off)
LED Mode (OFF, ON or Paging, factory set to Paging)
Line Out Control
DTMF Regeneration
Mute Current / Next Alarm
Permanent Alarm Mute
Programming User name and Password
IP Firmware
Phone Firmware
Import/Export
Clear Speaker Settings
Clear IP Settings
Night Ringing
Time Zone Settings/daylight Savings Time
1. Unit Name
Up to a 31 character unit name can be assigned to the 40-IP being programmed.
2. Peer to Peer Settings
When set to Peer to Peer mode a SIP server is not used. The unit should be programmed with a Static IP Address and
Username, a password is not used. Caller ID can be programmed if needed. Simply call the unit by entering the
programmed "username@192.168...(Static IP address for the unit)". The static IP address is normally programmed into
a page button on the VoIP telephones. NOTE: Peer to Peer mode does not affect Multicast paging.
Programming Features Index
Programming Features
10
Section
Page
A
8
1
10
2
10
3
11
4
11
5
11
6
11
7
12
8
12
9
12
10
13
11
13
12
13
13
13
14
13
15
13
16
13
17
13
18
14
19
14
20
14
21
14
22
14
23
14
24
15
25
15
26
15
27
15
28
15
29
16
30
16
31
16
32
16
33
16
Advertisement
Table of Contents
