Table of Contents
Advertisement
3. Alternate Server
When registered to a SIP server in the event that registration is lost you can program the unit to re-resolve using the
current SIP server IP address or route pages through an alternate SIP server. With Alternate Server selected enter the
IP address of the alternate SIP server in the field next to the Register Fails drop down box.
4. Security Code
The security code allows the user/installer to program the 40-IP phone. The factory set security code is 845464. It is
recommended that the factory set security code be changed.
Note: The security code must be 6 digits and cannot include a Q or a #.
5. Access Code
The Access Code is used for remotely operating the optional RC-4A relays (Doorstrike, Mag-Lock, etc) by calling into
the unit. This code provides basic security and only allows operation of the relays and not the ability to change any of
the programming parameters. Once entered, any of the "Remote Access Operation Commands" can be used. The code
can be 1 to 6 digits in length and cannot contain a "Q" or "#" or match the numbers used for the security code. Simply
call the 40-IP speaker (set to auto-answer/auto-answer secure), the unit will automatically answer the line and output
one beep. You then enter the programmed 1 to 6 digit access code, 2 beeps should be heard. You can now enter any
"Optional RC-4A Remote Access Operation Commands" (see page 17). This code is also required to enable SIP Paging
in the secure mode. The access code can be cleard (by leaving the field blank) if level of security is not required.
6. SIP Page Priority over Multicast Page
Incoming 40-IP SIP call audio streams can be programmed to have priority over any of the 10 Multicast paging groups.
Simply Use the "Sip Page Priority Level" drop down menu to select which Multicast group you want SIP calls to have
priority over. This is factory set to "0" (highest priority).
11
Advertisement
Table of Contents
